Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
redhat:virtualization-redhat:start [2020/04/01 12:05] – [Configure KVM Environment] michael | redhat:virtualization-redhat:start [2020/09/02 12:37] (current) – michael | ||
---|---|---|---|
Line 8: | Line 8: | ||
+ | * [[redhat: | ||
* [[redhat: | * [[redhat: | ||
Line 192: | Line 193: | ||
<WRAP center box 100%> | <WRAP center box 100%> | ||
- | '' | + | ==== Allow QEMU/KVM Commands for personal user: ==== |
If you want to allow your login user (non-root) to run virsh command or other KVM/QEMU commands, or use these commands without sudo, (needed by cockpit) then add your login user to the libvirt group as follows: | If you want to allow your login user (non-root) to run virsh command or other KVM/QEMU commands, or use these commands without sudo, (needed by cockpit) then add your login user to the libvirt group as follows: | ||
Line 202: | Line 203: | ||
<WRAP center box 100%> | <WRAP center box 100%> | ||
- | '' | + | ==== Setup own VM-Storage / ISO-Storage configuration: |
- | ---- | + | **Create needed directories**: |
- | + | ||
- | Create needed directories: | + | |
< | < | ||
Line 215: | Line 214: | ||
---- | ---- | ||
- | Make the virsh pool configuration changes: | + | **Make the virsh pool configuration changes**: |
- Listing current pools: < | - Listing current pools: < | ||
Line 223: | Line 222: | ||
default | default | ||
</ | </ | ||
- | - Destroying pool:< | + | - '' |
- | - Undefine pool:< | + | - '' |
- | - Defining a new pool with name " | + | - '' |
- | - Set pool to be started when libvirt daemons starts:< | + | - '' |
- | - Start pool:# virsh pool-start default</ | + | - '' |
- | - Checking pool state:< | + | - '' |
Name | Name | ||
------------------------------------------- | ------------------------------------------- |